How to connect an Atmel ICE to an Arduino Uno?

How to connect an Atmel ICE to an Arduino Uno?

This article explains how to connect an Atmel-ICE to an Arduino Uno via the ICSP header as used in the book C Programming with Arduino . It applies to the Atmel-ICE USB programmer debugger, with part number atatmel-ice and the cheaper Atmel ICE basic, part number ATATMEL-ICE-BASIC .

Which is part number for Atmel ICE debugger?

It applies to the Atmel-ICE USB programmer debugger, with part number atatmel-ice and the cheaper Atmel ICE basic, part number ATATMEL-ICE-BASIC . Either the atatmel-ice or atatmel-ice-basic can be used with the book instead of the AVR Dragon or AVRISP mkII. The Atmel-ICE has both programming and debugging capabilities.

What kind of connector do I need for Atmel ICE?

Connect the Atmel-ICE ribbon cable into the Atmel ICE via the connector marked AVR on the body of the Atmel-ICE. The 20 pin (5 × 2) fine pitch connector at the end of the cable plugs into the Atmel-ICE AVR connector.

Which is better Atmel ICE or atatmel ice basic?

The Atmel-ICE Full Kit (ATATMEL-ICE) is more expensive than the basic version and has additional connectors in the box. The Atmel-ICE Basic Kit (ATATMEL-ICE-BASIC) comes with a USB cable and one ribbon cable and is cheaper than the full kit.

How to programming ATmega328P microcontroller with Arduino IDE?

Upload takes only a few seconds, same as the Arduino board. Note: when programming the Atmega328p MCU using the Arduino IDE, the matching board type you have to select is the “ Arduino Duemilanove or Nano w/ ATmega328 ” board. To test the setup, we will use the Arduino blink example. Select the example and click upload.

Where is the ICSP header on an Arduino Mega?

Connect the 6 pin (3 × 2) header found at the other end of the ribbon cable to the ICSP header of the Arduino MEGA 2560. Make sure that the key that protrudes from the 6 pin connector at the end of the ribbon cable points towards the USB connector side of the Arduino MEGA.

Where is the ICSP header on an Arduino Uno?

Connect the 6 pin (3 × 2) header found at the other end of the ribbon cable to the ICSP header of the Arduino Uno. Make sure that the key that protrudes from the 6 pin connector at the end of the ribbon cable points towards the USB connector side of the Arduino Uno. See the images below to verify the connection.