Is the RF module connected to Pb3 on the ATtiny?

Is the RF module connected to Pb3 on the ATtiny?

The RF module is connected (data pin) to PB3 on the ATTiny. But I am having some problems. It does not work, and I don’t know why. My code: The code you presented does not fit for working with the RF 433Mhz. I’m not sure what you think this code should do, but this is not the way to go with a 433Mhz transmitter.

Which is part of the attiny85 Arduino board?

The board has the ATtiny85, a voltage regulator, and a handful of other parts. Schematic (courtesy of Digistump Wiki): More information about the Virtual USB idea at USB-Keyboard with Arduino and V-USB library, an example. Share Improve this answer

Can an attiny85 IC communicate with a computer through USB?

ATtiny85 communication with computer through USB Ask Question Asked5 years, 5 months ago Active11 months ago Viewed24k times 10 4 I am trying to receive and send some data from a computer to an ATtiny through USB. Can an ATtiny85 IC communicate with a computer through USB? If yes, how should it be connected?

Can a Arduino be used with a 433mhz transmitter?

The code you presented does not fit for working with the RF 433Mhz. I’m not sure what you think this code should do, but this is not the way to go with a 433Mhz transmitter. I would suggest using a dedicated library for transmitting information using the 433.

How to send and receive data between attiny85?

I then send a station identifier ‘2716’, followed by 3 values: Humidity, temperature, light. The receiving station then can identify where it came from and process the incoming signals (starting by dividing them by 100 again) 5 People Made This Project!

How to connect a VCC to an ATtiny?

Connect the datapin (usually either one of the two middle pins) to pin PB1 (physical pin6) on the attiny. Connect Vcc and ground of the LCD to Vcc and Ground. Attach a 17 cm (1/4 lambda for 433 MHz) to the Receiver module. The LCD is ofcourse optional.

Is there a RF module for the arduni Uno?

I have this cheap RF link that I had working with the Arduni UNO, but I wanted to make it smaller and ATTiny85 should do the trick. The RF module is connected (data pin) to PB3 on the ATTiny. But I am having some problems.

Which is the best library for attiny85 Tx / Rx?

There are many libraries out there for doing that; two popular libraries would be the ManchesterRF and the VirtualWire, both includes code samples. In addition, there are many other blogs around going step-by-step how to use 433Mhz Tx/Rx with ATtiny85, google is your friend 🙂