Why are my devices not connecting to eero?

Why are my devices not connecting to eero?

Power cycle your eeros: Try power cycling your eeros by unplugging the power cable from the back of your eero, waiting 30 seconds, and plugging it back in. This step can sometimes fix connectivity issues. Unplug the power cable from your modem, wait 30 seconds, then plug it back in.

How do I know if my ESP8266 is connected to WiFi?

To verify the connection status, open the Serial monitor, press the button connected to your ESP module and hold it for 5 seconds until you see the message “Starting Access Point” in your serial monitor: 18. Now that the Access Point is created, you can establish connection from your phone.

Where is the reset button on my eero?

The eero Beacon reset button can be found on the left side and the same instructions below apply. Before resetting your eero, make sure it has been powered on for at least 45 seconds. You can use the reset button to perform two distinct actions: a soft reset and a hard reset.

Do I plug eero into WAN or LAN?

Your Eero must be connected to a modem in order to provide the local network with an Internet connection. Acquire an Ethernet cable. Take one end of the cable and plug it into the Internet (or WAN) port on the rear of your Eero.

Is there a troubleshooting guide for ESP8266?

ESP8266 Troubleshooting Guide. The ESP8266 has a few common issues, specially when you are trying to flash a new firmware or uploading scripts. This is a companion guide to the Home Automation using ESP8266 and Password Protected Web Server eBooks.

Why is data connection necessary for setting up my Eero network?

Why is a data connection necessary for setting up my eero network? How do I check my eero OS software version? How do I access my eero network if I get a new phone?

What should I do if my Eero is not working?

Unplug the power cable from your modem, wait 30 seconds, then plug it back in. Depending on the model of your modem, it can take a few minutes to restart. Put your modem/router combo device in bridge mode: If you’re plugging your gateway eero into a modem/router combo device, put this device in bridge mode. Check here for tips on how to do this.

What causes ESP8266 to crash when using Lua?

On using 3.3 volt supply from external sourcesolved all such problems. Making system reliable. Expecting more work from u for NodeMcu with Lua. You are right Sanjay, most of the ESP8266 unexpected behavior is due to power supply issues that causes the ESP to crash.